 |
|
Microphone Input:
3 pin XLR connector, with switchable phantom power. Gain range +16 to +60dB, plus 30dB pad switch. EIN -126dBu, 20Hz - 20KHz @ 60dB gain, Zin = 150 ohms. Maximum input level +30dBu (with pad)
Line Input:
3 pole TRS 0.25 jack sockets, compatible with balanced and unbalanced inputs. Input Gain range: +/-20dB. Maximum input level with all gain controls @ 0dB: +18dBu. Maximum input level with Input Gain @ minimum: +26dBu. Hum and noise: -82dBu with compressor in and all gain controls @ 0dB
Instrument Input:
2 pole 0.25 jack sockets, front panel mounted with chrome bezel, switchable to high or low gain
Input Impedance:
1M ohm
Hi input:
Gain range -10dB to +30dB, maximum input level +6dBu
Lo input: Gain range -26dB to +14dB, maximum input level +26dBu
Output:
3 pole TRS 0.25 jack sockets, balanced (unbalanced compatible)
Output Gain range:
+15dB maximum
Maximum Output level:
+26dBu (balanced), +20dBu (unbalanced)
Frequency Response:
+0, -1dB: 20Hz to 20KHz, Line input @ 0dB gain, or mic input @ 40dB gain
THD:
Typically 0.2% at nominal level and 1KHz. Distortion is predominately even harmonic, increasing with tube Drive level
Compressor:
Threshold variable +10dB to -20dB, increasing compression as control turned clockwise. Ratio variable from 1:1.5 (gentle compression) to 1:30 (near limiting). Attack time switchable Fast (typically 0.5msec, but program dependant) and Slow (typically 5msec). Release time switchable Fast and Slow (typically 0.2sec and 1.5 seconds). Knee switchable Hard and Soft. Compressor On switch with LED
FAT EQ:
Applies preset FAT EQ curve of +4dB @ 90Hz, -2dB @ 800Hz and +2.5dB @ 10KHz. Overall loudness compensation
Meter:
Illuminated moving coil VU meter, switchable to Output Level or Gain Reduction. Calibrated for 0VU = +4dBu, plus 10dB pad switch effective on output level, for monitoring high output levels (0VU = +14dBu)
|
 |
 |
|
|
 |
 |